Gtco Super L III - Users Guide Manuale Utente Scaricare il pdf (Pagina 21)

Super L III 21

Introduction to the Tablet Configuration Utilities

The Super L III with its Controller uses the Tablet Configuration Utilities to control baud

rate, data format and other operating characteristics.

Communication Options

 Baud: The rate, in bits/second, at which characters are transmitted across the RS-

232C serial interface. Choices are: 1200, 2400, 4800, 9600, 19200 or 38400.

 Data Bits: Data bits represent the actual data being sent from one device to

another. Both devices must be set for the same number of data bits. Choices are:

Seven (7) or Eight (8).

 Stop Bits: Each character has one or two stop bits, which tell the receiving device

that a character is complete. The number of stop bits usually does not matter.

Setting for two stop bits instead of one may overcome a mismatch in parity or data

bits. Choices are: One (1) or Two (2).

 Parity: One bit can be allocated for parity (parity is a simple error-detecting

scheme). Both devices (sending and receiving) must be set for the same parity –

either odd parity or even parity – or they must be set for no parity. Choices are:

None (N), Even (E) or Odd (O).

Output Format Options

 GTCO: Selects GTCO-compatible formats. See Advanced Programing Information for

greater detail on GTCO format structure. Choices are: Binary or ASCII.

 CalComp: Selects CalComp-compatible formats. See Advanced Programming

Information for greater detail on CalComp format structure. Choices are: Binary,

ASCII 1, ASCII 2, ASCII 3 or ASCII 4.

 Summa: Selects Summagraphics-compatible formats. See Advanced Programming

Information for greater detail on Summagraphic format structure. Choices are:

Binary or ASCII.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Nessun commento

Gtco Super L III - Users Guide Manuale Utente Pagina 21