Gtco Roll-Up III - Users Guide Manuale Utente Scaricare il pdf (Pagina 5)

Roll-Up III 5

Parts Checklist

 Roll-Up III digitizing tablet

 Transducer (stylus/pen, 4-button or

16-button cursor)

 USB cable

 CD-ROM with Windows Drivers and

user’s manual

 Accessory case*

 Cardboard tube, insert and end

caps*

*Do Not Discard

Optional Equipment

 Computer interface cable with 9-pin

connector for serial connection

 Power supply – required only for

serial installations

 Deluxe travel bag

What You Will Need to Use Roll-Up III

 A computer running a Windows operating system with USB port, or an RS-232C

serial communication port. (Serial signal levels must conform to EIA RS-232C

specifications.)

 Application software that accepts digitizer input via the Wintab API, or application

software that directly accepts digitizer input via the computer’s RS-232C serial port.

Setting Up Your Roll-Up III

The instructions below describe how to set up your Roll-Up III. Before you begin, please

take a moment to fill out and mail the Warranty Registration Card or register your digitizer

on our website at http://www.gtcocalcomp.com/warranty-information.

Software Configuration

Software drivers provide the communication bridge between your digitizing software

application and the Roll-Up III. You should install only the drivers necessary for the Roll-Up

III to work with your application software. The GTCO CalComp by Turning Technologies-

1 2 3 4 5 6 7 8 9 10 ... 47 48

Nessun commento

Gtco Roll-Up III - Users Guide Manuale Utente Pagina 5