Gtco DrawingBoard VI - Users Guide Manuale Utente Scaricare il pdf (Pagina 13)

DrawingBoard VI 13

3 Save and 3 Restore Keys

The Save and Restore keys work hand-in-hand. They are used to save, or recall/restore, a

setup to or from one of three Save Areas. The tablet comes with three pre-programmed

setups. You can use these setups directly or overwrite them with your own. The Default

Save Key controls the first Save Area. The setup saved to this area is activated whenever

you power-up the digitizer. We recommend you save the setup you use most often as

Default.

Selecting a Pre-Programmed Setup

There are three pre-programmed setups available with DrawingBoard VI:

 GTCO CalComp by Turning Technologies DP5 High Resolution Binary

 Summagraphics MM 1201

 CalComp 2000 ASCII

These setups are commonly used within software applications as required tablet formats.

They are stored in Save Areas Default, 2 and 3, respectively. Check the manual that came

with your software package to see if your application requires one of these pre-

programmed setups. The Default setup is available when you power on the digitizer.

To select one of the other setups:

1. Turn on Configuration Mode by clicking on the Config/Exit key.

2. Click on the desired Restore key.

3. Click on the Config/Exit key again to exit Configuration Mode. The new

setup is activated.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Nessun commento

Gtco DrawingBoard VI - Users Guide Manuale Utente Pagina 13