Gtco DrawingBoard V - Quick Start Guide Manuale Utente Scaricare il pdf (Pagina 3)

USB Connection – With TabletWorks CD Only –

1. Connect the corded transducer – cursor or pen – to the appropriate jack on the

digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.

Do not force it.

2. Attach the USB interface cable to the USB jack on the DrawingBoard V Connector

Panel. The connector is keyed and will fit only the correct jack. Do not force it.

3. Join the other end of the USB cable to any one of the USB ports on your

computer or USB hub. Turn the power switch on. The digitizer will beep once,

indicating it has power.

NOTE: Power is supplied through the USB port. No additional power source is needed for

a USB installation, unless you are using DrawingBoard V with a corded high-accuracy

cursor. For that configuration only, connect the power supply before making the USB

connection.

4. If Windows displays the Found New Hardware prompt, follow the onscreen

instructions to finish the Found New Hardware process.

1 2 3

Nessun commento

Gtco DrawingBoard V - Quick Start Guide Manuale Utente Pagina 3